Registration Mark Sensor Error Vinyl
Registration Mark Sensor Error Vinyl. It will return to default screen. 5 press the enterkey to register your settings.
The registration sensor error is caused when the silhouette cutting machine is looking for registration marks that are not printed on the material. The optic scanner is obstructed; For best results, use a machine mat with few or no marks or smudges.
Make Sure You Stick The Sticker Piece On Your Hands Several Times So That You Can Peal It Off Before It Start Cutting.
Press the f4key (slow) to select the slow feed speed, and the f3key (normal) to select the normal feed speed. When it does not read register marks, the position of the register sensor and light pointer may not match. Try to unload the mat, rearrange your paper on the mat and then reload the mat into the machine.
Press The [2] Key (Arms).
To further assist you to setup and calibrate a vinyl cutter with built in registration mark detectors (sensors) and/or a laser pointer the vinyl spooler comes with a laser offset calibration tool along with practice sheets so you can learn how to perform super. This can be printed on a letter size bond paper of desktop printer. Necessary tools needed will be the graphtec plotting pen, or blade if prints are on vinyl, pdf files:
Another Thing, If The Prints Are Laminated, Try Cutting The Laminate From Around The Registration Marks, Apply Transfer Tape Over The Marks And Then Re Draw With A Felt Tip Marker Or Fine Tip Sharpie.
Necessary tools needed will be the graphtec plotting pen, or blade if prints are on vinyl, pdf files: It will return to arms setting screen (3/4) once the adjustment is completed. The optic scanner is obstructed;
It Will Return To Default Screen.
8) confirm the position of the tool, and if it is ok, press the [enter} key. Grab another set of registration marks we already made and put it on top of the red one. Switch from automatic to manual as the error message suggests (often overlooked!).
It Is Rare That An Advanced Registration Mark System (Arms) Is Defective, Before Calling Tech Support Please Isolate The Cutter (Sensor) By Performing An Arms Test:
Alternatively, you can try to manually read the registration marks by. Press the position ( ) key twice. The squares/registration marks should turn red just like the heart.
Post a Comment for "Registration Mark Sensor Error Vinyl"