2010 Ford Focus Tire Pressure Sensor Fault Reset

2010 Ford Focus Tire Pressure Sensor Fault Reset. How do you reset the tire pressure sensor on a 2010 ford ranger? Scroll through to driver assist and press ok.

TPMS fits Ford Focus 2014 Tire Pressure Sensor from www.oewheelsllc.com

I would recommend doing a hard reset by disconnecting the 2 battery terminals and holding them together for 30 mins. The error code may tell you that the tires’ air pressure is too low or too high or that one of the tire pressure sensors is defective. Checked all tire pressures satisfactory and reset again.

Source: www.f150forum.com

Cycle ignition from off to run position 3 times, ending in run position. The light stayed off for about 50 miles.and came back on.

Source: www.oewheelsllc.com

When its started up, the message “tire sensor fault” appears along with the low tire icon flashing (steady light after ~30 seconds). The smj(smart junction box) or gem might need to be reset as this is the item that puts it into learn mode.

Source: www.ebay.com

Some vehicle models reset at higher speeds. Hopefully, all worked well for you and you have completed resetting the tpms on the ford focus.

Source: www.oewheelsllc.com

There is most likely an issue with a tire pressure sensor or the connection to the sensor. Your tire pressure monitor system has failed, you should still be under warranty but if not it is safe to drive if you don't have the money to get it fixed right away.it may be something as simple as a wire off or a ground.

Source: trechytay.blogspot.com

Once your vehicle enters tpms reset mode, the horn will sound once and a message will. Start from the driver side front tire, remove the valve cap, and then increasing or decreasing the tire’s air pressure until a horn chirp sounds.

Source: www.ebay.com

Repeat the process for the passenger side front tire, passenger side rear tire, and the driver side rear tire. Scroll through to driver assist and press ok.

Scroll Through To Driver Assist And Press Ok.

Adjust the tyre inflation pressure recommended on the tyre placard located on the door panel. When the horn honks, the car is in learning mode. Use your vehicle's tpms reset button.

If Playback Doesn't Begin Shortly, Try Restarting Your Device.

2) turn the ignition switch from the off position to the run position three times, ending in the run position. Quickly switch the hazard flashers on then off 3x. Now press and hold ok.

The Light Stayed Off For About 50 Miles Again.

I would recommend doing a hard reset by disconnecting the 2 battery terminals and holding them together for 30 mins. And if it is not getting the reading, it will throw a fault code for one or more tire pressure reading. Put the key in the ignition and turn it to the on position, but do not start the car.

Turn The Engine Switch To The “On” Position

It may take up to two minutes of driving before the tire pressure sensor fault light to go off. Being that i live in florida, the air is 95 degrees and humid. Best to use a digital pressure guage if at all possible.

To Reset The Tyre Pressure Light On Your Ford Focus, Follow These Instructions:

I can then press the reset button on my dash to clear the message. Before going thru all of this if you haven't done a reset you should, just to see if it works. The error code may tell you that the tires’ air pressure is too low or too high or that one of the tire pressure sensors is defective.