La Crosse C83100 Rain Sensor Not Working
La Crosse C83100 Rain Sensor Not Working. 1) wait until overnight for signal to be received 1) humidity is below 1% or above 99%.
Be sure to mount the rain sensor level. • if there is no loss of signal in that hour, move the rain sensor just outside. The lacrosse weather station model 86111 trying to replace the sensor with the prescribed sensor tx141v2, however it does not work.
This Shield Will Offer Limited Protection From The Sun's Heat.
After reading some posts of insects in the instruments i found a tiny spider web in the 4 small holes from the water collector of the rain gauge. Out side temp does not work. Sensor shield only, sensor is not included.
The C83100 Station Can Display Data From One Temperature & Humidity (Th) Sensor, One Wind Sensor And One Rain Sensor.
Click here to enter your system model number and confirm the compatible sensor(s). Your wind sensor should be the tallest object in the area to avoid reduced wind speed values. Be sure to mount the rain sensor level.
Check The Sensor Often To Remove Leaves Or Other Debris That Could Cause Low Rainfall Readings.
No more spider or web and gauge is reading now. • if there is no loss of signal in that hour, move the rain sensor just outside. Looking for a compatible sensor or part?
If There Is A Consistent Problem, Please Call La Crosse Technology.
Click on the specs tab below for the full list of compatible sensors. With rain sensor mounted slowly pour water into the funnel to tip the rocker of the rain sensor 10 times. Checks rain every 45 seconds.
Use A Volt Ohm Meter And Set The Plus Lead At The Reed Switch Lead At The Top Of The Board.
La crosse technology user manuals la crosse technology ltd. Yes it is the magnetic reed switch that stops working. The c83100 station can display data from one temperature & humidity (th) sensor, one wind sensor and one rain sensor.
Post a Comment for "La Crosse C83100 Rain Sensor Not Working"