Aim Brake Pressure Sensor Installation
Aim Brake Pressure Sensor Installation. The drawing here below shows sensors dimensions in. This requires careful cutting, deburring, and flaring of the brake line, working from the engine bay.
Attach the supplied pressure sensor to the end of the brake line adapter. Whether your bike is equipped with single, dual, fixed or adjustable master cylinders, adding brake pressure sensors allow you to monitor brake performance, make fundamental changes and identify issues quickly and. Dimensions, pinout and technical characteristics.
Whether Your Car Is Equipped With Single, Dual, Fixed Or Adjustable Master Cylinders, Adding Brake Pressure Sensors Allow You To Monitor Brake Performance, Make Real Changes And Identify Issues Quickly And Precisely.
Remove brake line from brake master cylinder. Reconnect the vehicle brake line to the tee adapter. That’s it, now i had a proper oil temp reading… only one problem;
The Sensor Uses A Thin Layer Technique To Achieve High Accuracy Pressure Measurements.
The kit is composed of: Attach the supplied pressure sensor to the end of the brake line adapter. Whether your bike is equipped with single, dual, fixed or adjustable master cylinders, adding brake pressure sensors allow you to monitor brake performance, make fundamental changes and identify issues quickly and.
Aim Devices Can Measure Brake Pressure With A Proper Sensor.
(the data in the abs pcm is: Whether your car is equipped with single, dual, fixed or adjustable master cylinders, adding brake pressure sensors allow you to monitor brake performance, make real changes and. The sensor is specially designed to measure absolute pressure in gasoline direct injection applications.
Aim Magnetic Wheel Speed Sensor, 719 Lead
I caught the mistake before installing in the car, and the correct fluid temp sensor was sent in exchange. Engine temperature, water/oil, and tire temperature can be constantly monitored as well as oil pressure and brakes fluid pressure, displayed in real time on the dashlogger they interface with. Setup with race studio 3
In This Datasheet It Is Loaded Using Race Studio 3 Software.
A brake pressure sensor is a powered sensor that typically has three wires; You must have a 37 degree an flare tool. Due to the length of the hard lines in the mk20 abs system, this kit will require installation of the brake pressure fitting on the car.
Post a Comment for "Aim Brake Pressure Sensor Installation"