2008 Dodge Charger Camshaft Sensor
2008 Dodge Charger Camshaft Sensor. It is located on the backside of the engine under the intake manifold. I have a 2008 dodge charger se 2.7l engine and i’m experiencing terrible cranking/starting issues and no one seems to be able to diagnose the issue!
1a auto has a large selection of camshaft (cam) position sensors for your 2008 dodge charger and ground shipping is always free! Disconnect the negative battery cable. This video represents a 2007 model which is only 2 years apart from your 2009 but the parts and placement should be the same or at least fairly close.
Dodge Charger 2008, Camshaft Position Sensor By Walker Products®.
Choose top quality brands api, bwd automotive, beck arnley, bosch, carquest, diy solutions. The camshaft position sensor (cmp) is located just below the oil fill cap. Locate the camshaft position sensor, it is on the passenger side in the front on the block.
Remove 10Mm Bolt And Remove Camshaft Sensor.
If the problem happens above 3000 rpm, it may have a camshaft drive gear tone ring separation issue occurring. 1a auto has a large selection of camshaft (cam) position sensors for your 2008 dodge charger and ground shipping is always free! If you are experiencing a hard start situation, engine stalling, rough idle and getting an obdii engine trouble code of p0340 or 0340 camshaft position sens.
Ok, There Are A Couple Of Different V6 Engines Offered For The 2006 Charger, So Here Is Location For Each:
If not then your crank sensor is more then likely the problem. It is a generic code, which means that it has the same meaning for the dodge charger as it would any other vehicle. Hi, i've been experiencing trouble with my vehicle, a 2008 dodge avenger, for awhile now.
It Is Located On The Backside Of The Engine Under The Intake Manifold.
View with engine cover removed. Check if this fits your 2008 dodge charger. Fuel injectors (on each side of intake manifold) camshaft position sensor (cmp) (located at the front of pass side cylinder head) oil pressure sensor (pass side behind alternator) knock sensors (ks) (rear of engine under exhaust manifolds)
This Information Is Used By The Engine Control Module ( Ecm) To Control Ignition And Fuel Injection.
Locating a bank 2 sensor 1 in a 2008 dodge charger. Disconnect the negative battery cable. The camshaft position sensor senses the retraction of camshaft (intake) to identify a particular cylinder.
Post a Comment for "2008 Dodge Charger Camshaft Sensor"