How To Test System Sensor Heat Detector
How To Test System Sensor Heat Detector. Test the detector using the magnet as described under testing. Demo of the system sensor 5601p heat detector.discord server to engage with the community and earn alarms & mystery boxes:
Hold the heat source about 15 cm away to prevent damage to the cover during testing. For more information on system sensor detectors call us now on 01200 428 410. The system sensor detector range includes smoke, heat and multi criteria detectors.
Reset The Detector At The System Control Panel.
With it's high fixed temperature alarm threshold, the. When selecting the location on the ceiling for the heat sensor, do not locate it in direct path of hot or cold air flow. Testing before testing, notify the proper authorities that the smoke detector system is undergoing maintenance and will temporarily be out of service.
Test Each Detector As Described In Testing.
Notify the proper authorities that the system is in operation. Heat detectors for fire protective signaling systems. The picture below shows where the vents are located on the detector:
After All Detectors Have Been Installed, Apply Power To The Alarm Control Unit.
This detector has a unique ir activation and uses cross air technology for optimum energy use and results. Alphanumeric characters identify the activation method, as well as the temperature rating, in fahrenheit and celsius degrees. Resettable temperature sampai 120°c (248°f) (analog)
To Test A 521Bxt For Heat Detection, Use A Hair Dryer On Its Maximum Setting To Pass Hot Air Back And Forth Across The Device.
Heat gun, hair dryer, or heat lamp “do not overshoot the set point of the unit by more than 100°f (55°c), this could result in a shift of the set point temperature.” “do not contact the sensing shell with heating device such as a soldering iron or blowtorch as this will damage the unit and cause a. There are two test methods: If any heat (change in heat that exceeds the limits of heat sensor ratings) is sensed by the heat sensor, the heat sensor generates a signal for alerting or activating a security or protection system to extinguish or avoid the fire accidents.
Test Each Detector As Described In Testing.
Notify the proper authorities that the system is back on line. With a range of several metres, the hand held test unit provides a fast and simple way of remotely alarm testing the range of eco1000 detectors and removes the need for any direct physical access to the detector by the user. Reset all the detectors at the alarm control unit.
Post a Comment for "How To Test System Sensor Heat Detector"