2011 Jeep Grand Cherokee Crankshaft Position Sensor Location
2011 Jeep Grand Cherokee Crankshaft Position Sensor Location. There is a small metal heat shield covering it. Jeep grand cherokee crankshaft position sensor replacement at your home or office.
I also never had to get under the jeep to accomplish the task. A failing crankshaft position sensor cannot provide the right information about piston positioning in the engine, causing a cylinder to misfire. Engine speed and crankshaft position are provided through the crankshaft position sensor.
Our Certified Mobile Mechanics Can Come To Your Home Or Office 7 Days A Week Between 7 Am And 9 Pm.
This could also occur from faulty spark plug timing, but if the spark plug checks out, then the crankshaft sensor is likely the source. By continuing to use this site you consent to the use of cookies on your device as described in our cookie policy unless you have disabled them. The most recently reported issues are listed below.
Anyway, That Is My Experience.
This is by no means the only way or correct way to replace the sensor. This is only the way i changed the sensor. My 2011 grand cherokee v6 has a check engine light with the camshaft position sensor code (p0340).
This Sensor Uses A Reluctor To Gauge The Position Of The Crank.
Rough idle and/or vibrating engine. Location of crankshaft position sensor jeep grand cherokee 1997 left rear of engine block,on transmission bell housing.best way from top under brake booster use a wrench, posted on jun 13, 2009 It is located at the back of the engine on top of the transmission bell housing,the plug runs over to the passenger side of the engine bay and it comes out from behind the engine,you can actually get your hand on the sensor itself from under the hood on the drivers side,and i believe its a 13mm bolt holding it in,the new sensor will have a sticker.
The Crankshaft Position (Ckp) Sensor Is Mounted Into The Right Rear Side Of The Cylinder Block.
See directions i have attached Locate the crankshaft position sensor on the driver side of the bell housing, about half way down. In my research, i have read it could be the camshaft position sensor, the crankshaft position sensor or cam phaser.
Free 50 Point Safety Inspection.
Jeep grand cherokee crankshaft position sensor replacement at your home or office. This is going to be a how to on replacing the crankshaft position sensor on the 4.0l motor in the grand cherokee. Another sign of a crankshaft position sensor problem is.
Post a Comment for "2011 Jeep Grand Cherokee Crankshaft Position Sensor Location"