Replaced Crank Sensor Now Truck Wont Start

Replaced Crank Sensor Now Truck Wont Start. Discussion starter · #1 · mar 24, 2010. Make sure you give your car a major tune up.

Car wont start when hot Audi crankshaft sensor location v6 from www.youtube.com

Dash lights up goes out when u turn key to start. The most common failure is the crankshaft position sensor. Silverado turns over like it wants to start, so i checked for spark, but there is none.

Source: www.youtube.com

Removed oil cap, made sure timing chain was moving while cranking. There are a number of engine issues that may be linked with a truck cranking but failing to start.

Source: www.youtube.com

Its sensing when the crankshaft is in the correct position, if. If you disconnected the battery before replacing the sensor, this could be one cause of the vehicle not to start.

Source: www.2carpros.com

The most common failure is the crankshaft position sensor. Still, will crank, won't start.

Source: www.justanswer.com

I took my 2001 chevrolet silverado 2500hd, long bed, single cab, base model, 6.0l, gasoline, down to get the check engine light diagnosed when it came on and started running like crap (mainly in. Unplug the sensor and see if it starts.

Source: www.2carpros.com

Replaced ignition coil, nothing, replaced cap and rotor, nothing, replaced crank positions sensor, nothing, replaced icm, finally have spark. I put in a new cps and the tried to start it.

Source: www.2carpros.com

The truck started right up reved good so i let it idle. Replaced crankshaft position sensor now the truck wont start make sure you put it on right.

Crankshaft Position (Ckp) Sensor Replacement Removal Procedure Picture 1 1.

Freightliner cranks but won’t start. Something had to of happen when it sat for a week or something. I did a little research on this p0017 code and my haynes book is showing a crankshaft sensor code, if you have replaced the cam sensor and the truck will not start, you may have a bad crankshaft sensor, if you have a volt meter, you can back probe the connector, or unplug it and have somebody turn the key over and check for voltage at the plug just trying to.

It Can Also Occur If The Timing Belt Broke Or Jumped A Tooth.

Unplug the sensor and see if it starts. However, once i tried starting it back up without success, the code switched to the camshaft position sensor. I would do a compression test also to see if there is low compression.

2004 2500Hd 6:0 Engine 71000 Miles

I have unhooked the battery, done the relearn 3 times. Just replace my knock sensor and now the truck won't start. Disconnect the crankshaft position (ckp) sensor electrical connector (3).

Wasn't Getting Spark When Inchecked.

I took my 2001 chevrolet silverado 2500hd, long bed, single cab, base model, 6.0l, gasoline, down to get the check engine light diagnosed when it came on and started running like crap (mainly in. 1st though, i pulled out the camshaft sensor and thought that was it. Make sure you give your car a major tune up.

The Truck Started Right Up Reved Good So I Let It Idle.

The truck crank but wouldnt start. When your truck turns over but won’t start, the first thing you need to check before any troubleshooting is your fuel tank. Replaced ignition coil, nothing, replaced cap and rotor, nothing, replaced crank positions sensor, nothing, replaced icm, finally have spark.