2018 Chevy Traverse Tire Pressure Sensor Reset
2018 Chevy Traverse Tire Pressure Sensor Reset. If the low tire pressure warning light comes on, push and hold the tire pressure warning reset switch (think the switch is in the glovebox, but not sure) until the warning light turns off and then release the switch. Put the key in the ignition and turn it to the on position, but do not start the car.
Gm's tire pressure monitor employs a sensor inside each tire's valve stem. Inflate all tires to 3 psi over their recommended amount, then deflate them completely. A horn beep confirms the sensor id code has been matched to the tire and wheel position.
Turn Your Vehicle’s Key To The “On” Position Without Starting The Vehicle.
The tire monitor service light will come on instantly if the tire pressure is below 25 psi. When you have finished filling your tires with air, deflating them (in case of high psi), or changing a tire on your vehicle, you should always reset the tire pressure system. Additional tips for resetting your tire pressure light.
A Horn Chirp Will Confirm That The Sensor Has Been Reset.
Turn the ignition switch to the on position. After horn sounds proceed as in step 5 for the next 3 sensors in the following order: Inflate all tires to 3 psi over their recommended amount, then deflate them completely.
Start Your Vehicle And Let It Run For At Least 20 Minutes And Your Tpms System Should Be Reset.
Start from the driver side front tire, remove the valve cap, and then increasing or decreasing the tire’s air pressure until a horn chirp sounds. If you own an old model without an instrument cluster, press the odometer reset button until “tire learning active” message is displayed. Once your tires are properly inflated, the tire pressure light should turn off, however, if it remains on, there are a few additional steps you can take to turn it off:
Adjust All Tires To Pressure Listed On The Placard.
Gm's tire pressure monitor employs a sensor inside each tire's valve stem. Sensors must be professionally programmed and installed. This is a brand new tpms tire pressure sensor for 2018 chevrolet traverse.
Sometimes The Sensor System Simply Needs Resetting.
C.press and hold the set/clr button, and if prompted, select “yes” to confirm by pressing the set/clr button. Each tire has a sensor. Turn off the ignition after you reset the last tire.
Post a Comment for "2018 Chevy Traverse Tire Pressure Sensor Reset"