How To Bench Test A 4 Wire 02 Sensor
How To Bench Test A 4 Wire 02 Sensor. Take the sensor you want to use out of. The ecu system is designed to regulate the fuel amount entering the engine in relation to the level of oxygen measured by the o2 sensor.
So, if the check engine light (cel) is on and you've got diagnostic trouble codes (dtc) p0108, p0109 and you need to check the map. The oxygen, or o2, sensor reads the percentage of oxygen in the exhaust coming from the engine and sends this information to the computer. If continuity does not exist, the sensor cannot function properly;
4 Wire Sensors Have Been Used For A While So It Is Easy To Find Them At Junkyards.
Disconnect oxygen sensor multiplug and locate terminals 3 and 4 of the oxygen sensor. Bosch lsu 4.2 wideband o2 sensor testing (2001 skoda octavia 1.6 (avu)): The factory one wire oxygen sensor works well for what it was designed for but it does have limitations.
Connect The Positive Red Multimeter Lead To The Signal Wire On The O2 Sensor.
Set your multimeter to the millivolt (mv) dc setting or 2 dc volts setting. Three and four wire sensors add a heating element so the sensor starts operating faster and more reliably. Take the sensor you want to use out of.
The Difference Is That Instead Of Using The Body Of The O2 Sensor As A Ground, The Third Wire Is The Ground, Eliminating The Potential Of Poor Ground Between The O2 Sensor And The Exhaust System Making It More Efficient.
If continuity does not exist, the sensor cannot function properly; First, a disclaimerthe reader should be aware that i am not a professional and my knowledge of wideband sensors is limited. Using the dtc, you can refer to your owner’s manual to locate the sensor.
Your Owner’s Manual Will Also Identify The Signal Wire As Many O2 Sensors Have Multiple Wires Connected To It.
Approximately 3.5 ω @20 °c. The knock sensor should have continuity, which is a current electrical path between the wire and sensor. Tools needed to perform these tests:
If This Does Not Produce The Required Results, Check The Wiring For Continuity.
Park the vehicle on a level surface. Connect the red probe to the + wire going to the sensor, and connect the black probe to the ground wire going to the sensor. While the fix and testing wo…
.JPG)
Post a Comment for "How To Bench Test A 4 Wire 02 Sensor"