2004 Impala Oil Pressure Sensor Location
2004 Impala Oil Pressure Sensor Location. Hello, i have a 2008 impala ls 3.5 flex fuel. Yeah my oil pressure sensor on my 3.4l is leaking also, not quite as bad, i pulled off the connector and it had oil all over it., plus with a tech2 says there is a fault in the circuit.
How long does it take to replace a coolant teperature sensor and oil pressure switch. Hi stevie, your impala probably has a defective sensor, often called a switch that senses the oil pressure. It is in the valley of engine behind intake.at back of engine you can get it out with a thin walled oil sender socket.
The First Thing You Should Do, Is Check Your Engine Oil Level.
Guess i will get another sensor. Discussion starter · #1 · feb 21, 2016. Related oil pressure sensor location content.
Duralast Oil Pressure Switch Ps152.
Oil pressure sensor location please 3.8l. You will need to lower the sub frame and lower the transmission and engine to gain clearance to remove the cover. You will find it located directly behind the egr valve threaded into the block just to the drivers side of the center bolt for the transmission to block connection.
#14 · Jul 18, 2015.
If the sensor is acting properly, and pressure is low, it could really damage your engine to have low oil pressure and oil not. The problem was with the pressure control solenoid in the transmission. Best way to get to it is through the rear of the passenger side front wheel well.
That Is Where Mine Is Located However Mine Is A 2000 Chevy Impala Ls.
Posted on jan 15, 2009. Turn the wheel all the way to the left. Hello, i have a 2008 impala ls 3.5 flex fuel.
Your Looking Foer The Oil Pressure Sensor On The 2004 8.1L.
The low coolant level sensor is in the passenger side of the radiator. It is in the valley of engine behind intake.at back of engine you can get it out with a thin walled oil sender socket. I was at 91,000 miles but my next oil.
Post a Comment for "2004 Impala Oil Pressure Sensor Location"